3D Photoshop Cube 8/8 FINAL

3D Phohoshop Cube 7/8

3D Photoshop Cube 6/8

3D Photoshop Cube 5/8

3D Photoshop Cube 4/8

3D Photoshop Cube 3/8

3D Photoshop Cube 2/8

3D Photoshop Cube 1/8

Friday Post January 20, 2017 - Course Eval

What I liked about the course was that most of them were fun.

Stuff that could be improved um.... I don't know.

The minecraft building assignment was my favourite.

Code Combat

Keychain Moon Model 4/6

Link to STL

Keychain 3D Model 3/6

Link to STL

Friday Post - January 06, 2017

The Steps to Make an Oval Keychain using Sketchup

Step one: Click Choose Template

Step two: Click on Interior and Production Design

Step three: Click Start using Sketchup

Step four: Click on Camera at the top of the page

Step five: Click on Standard View and choose Top

Step five: Click on the Square with a line through it that says Shapes

Step six: Click on the middle of the green line and red line and type the numbers 100,40 while still holding the the mouse and press enter

Step seven: Put the mouse on the magnifying glass with arrows pointing outwards and click on it

Step eight: Click on the tape measure, next click on the top of the rectangle and drag down then type the number 5 then press enter and do the same for the bottom of the rectangle

Step nine: Take the tape measure and click on the left side of the rectangle and drag it inward to the middle of the rectangle and type the number 20 then press enter, do the same for the other side.

Step ten: Click on the circle that says Arcs, then on the dotted line going up and down click on the top of the rectangle and at the bottom of it too then drag it to the left till the mouse is at the edge, do the same for the other side

Step eleven: Click the middle of the two dotted lines where the cross over each other and drag the mouse to the middle of the dotted lines below the top one and click on it and drag the mouse to the left until the bottom right corner of the page says 15, do the same for the other side

Step twelve: Click on the pencil at the top of the page that says lines and drag the mouse to one of the small half circles and click on the middle of the to over lapping lines and drag the mouse to the other half circle, do the same for the bottom

Step thirteen: Click on the eraser and erase the dotted lines and the four corners and then the middle to erase the middle right click the mouse and click erase

Step fourteen: Click on the tool with arrows circling a line that says Orbit and drag the mouse up a little bit

Step fifteen: Click on the magnifying glass with arrows pointing outward

Step sixteen: Click on the tool with an arrow pointing up with and platform under it and drag the mouse to the oval and click on it and drag the mouse up and type the number 5 and press enter

Step seventeen: Click Tools at the top of the page and choose 3d text, type in your initials click on font and choose any font you want, click on align and choose centre, then click on height and type in 30 on the top and below it type 5 then click place and put your initials in the middle of the oral, check if you initials don't touch the top and the bottom click on the tool at the top of the page that says scale then click on your initials and click on any of the squares to re size your initials

Step eighteen: Click on the paint bucket and paint the keychain

My Prediction of my Final Grade

  

Keychain Shapes 2/6

Link to STL