Keychain Initals 1/6

Link to STL

Friday Post December 9

1. Start with a piece of printer paper.
2. Fold the corner of the paper inwards, making a triangle.
3. Then with scissors, cut off the extra side of the paper.
4. Now unfold the paper (making a square)
5. Next, you take one side of the paper and fold it over (making a rectangle)
6. Now take your scissors and cut along the fold to make it into two rectangular pieces of paper.
7. Then take one of the two pieces and fold one the long side onto itself.
8. Next take one of the long sides of the rectangle and fold it to the previous fold mark.
9. Do the same for the other side.
10. Now take the sort side of the paper and fold it onto itself.
11. After doing that take the short side of the rectangle and fold it to the previous fold mark.
12. Do the same for the other side.
13. Now you're going to fold one side of the little flaps in half.
14. Do the same for the other side.
15. Time to get a ruler.
16. Using your ruler draw a line between the second fold and the edge of the paper.
17. For the closed edge draw out a pattern of two, one, two for your lines and one, two, one for the other side.
18. Now get your scissors and cut along the lines and be careful to get both sides of the open edge.
19. Unfolding time.
20. Cut open the middle flaps along the fold line.
21. Time for tape.
22. Tape the middle flaps onto the outer flaps.
23. Add tape to where the two flaps meet up.
24. Do the same for the other side.
25. Now fold the outermost folds in towards the center and apply some tape.
26. Repeat to all the rest of the flaps
27. And your done!

Simple Toy Slideshow Tutorial